Minipro 6.85 !!hot!!

First layer peeling. Solution: Wash the PEI plate with dish soap. Oils from your fingers kill adhesion. Increase bed temp to 65°C for PLA.

: This is the last version that works with the original TL866CS/A hardware before the manufacturer switched to the newer XGecu T56 and TL866II Plus series. minipro 6.85

This device sits in a unique spot in the retro-handheld market: it is essentially a with a larger screen. First layer peeling

), which are necessary for older chips that require specific power levels to enter programming mode. Increase bed temp to 65°C for PLA

Measure numbers, clefs, and fingerings omitted for brevity—interpret as comfortable.

Version 6.85 is significant because it is the for the first-generation MiniPro hardware. The manufacturer, XGecu, has officially discontinued support for these models in favor of the newer TL866II Plus (and subsequent T48/T51 models).

For years, the TL866CS was the golden child: cheap, functional, and—crucially— to the more capable TL866A via a simple firmware flash.