Makerbase Mks Dlc V21 Manual Link Free Jun 2026

The is an all-in-one 32-bit control board for 3D printers and CNC/laser engravers. It combines an STM32F407VGT6 (or similar) main MCU with TMC2209 stepper drivers in UART mode, integrated Wi-Fi (ESP8285), RGB port, thermistor circuits, fan MOSFETs, and support for Marlin 2.x or Klipper .

Are you planning to use this board for a or a CNC router project? MKS DLC V2.1_001 PIN.pdf - hardware - GitHub makerbase mks dlc v21 manual link

: Once set up, you can use the MKS DLC V21 to control and monitor your machine. This could involve starting prints, monitoring temperatures, and adjusting settings on the fly. The is an all-in-one 32-bit control board for

Shared ground-triggered MOSFET output for controlling laser modules or CNC spindles. Setup & Firmware Installation MKS DLC V2

You can find all technical documentation and firmware for the MKS DLC series on the official and support pages: Main Documentation Hub : Makerbase MKS-DLC GitHub Repository Hardware Schematics : MKS DLC V2.1 Schematic (PDF) Pinout Diagram : MKS DLC V2.1 Pinout (PDF) Firmware Downloads : MKS DLC32 Firmware Repository Wiring Guide : MKS DLC32 V2 Wiring Manual Key Specifications and Features